Carrier-access Bridge/Router 3104s Manual de usuario descargar pdf (Pagina 20)

20 Adit 3104 - Release 1.6

Quick Start

Setting up a CLI Connection

A CLI connection will require the LAN or WAN IP address of the unit. Note: If the WAN IP address

is used, the remote admin WAN access must be enabled with the following command sequence:

NOTE: For Adit 3104 CLI commands see the Adit 3000 CLI Reference Manual. This is a

separate document and can be found on the CD that is provided with the product, or on the

Carrier Access customer website.

To connect with CLI, set up the connection:

z If connecting via the Ethernet 100Base-TX connection, use a Telnet TCP/IP program to access

the CLI. This requires an IP address of the unit.

Note: to display the current IP address of the unit, use the ifconfig command.

z If connecting via RS-232, the port settings should be set to:

Bits per second: 115200 Data bits: 8

Parity: None Stop bits: 1

Flow control: None

z Set your Terminal Emulation to: VT100

NOTE: When using Tera Term (Telnet program) TCP/IP, CLI commands will not be

recognized until the following setup is completed.

z In Tera Term go to Setup/Terminal

z Set the New-line/Transmit value CR+LF

Command Description

Username: admin

Password: ********

Log into the system (username and password).

Adit 3104> enable Enter the Privileged mode.

Password: ******** Enter password for the Privileged mode.

#configure terminal Enter the Configuration mode.

(config)# remote-admin web

primary-port enable

Enable remote web admin.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 33 34

Sin comentarios

Carrier-access Bridge/Router 3104s Manual de usuario Pagina 20