Carrier-access Adit 3000 Series and Multi-Service Router (MSR) Ca Manual de usuario Pagina 254

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 496
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 253
11-10 Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI
Configuration - Ethernet Interface Mode
ip ospf authentication-key
Use the Ethernet Interface ip ospf authentication-key command to assign a password to be used by
neighboring routers, that are using OSPF’s simple password authentication.To remove a previously
assigned password, see no ip ospf authentication-key command on page 11-18.
Syntax: (config-int-eth-{n})# ip ospf authentication-key password
Example: (config-int-eth-1)# ip ospf authentication-key pass777
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
ip ospf cost
Use the Ethernet Interface ip ospf cost command to define the cost of sending a packet on this Ethernet
interface. To reset the path cost to the default setting of 0, see no ip ospf cost command on page 11-18.
Syntax: (config-int-eth-{n})# ip ospf cost cost
Example: (config-int-eth-1)# ip ospf cost 5
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
ip ospf dead-interval
Use the Ethernet Interface ip ospf dead-interval command to define the interval of time that no hello
packets have been seen before neighbors declare the router down. To reset the interval of time to the
default setting of 40 seconds, see no ip ospf dead-interval command on page 11-18.
Syntax: (config-int-eth-{n})# ip ospf dead-interval seconds
Example: (config-int-eth-1)# ip ospf dead-interval 50
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
Field Definition
password Enter a password, with up to 8 characters.
Field Definition
cost Range is 1-65535, with a default of 0.
Field Definition
seconds Range is 1-65535 seconds, with a default of 40.
Note: This value must be the same for all nodes on the network.
Vista de pagina 253
1 2 ... 249 250 251 252 253 254 255 256 257 258 259 ... 495 496

Comentarios a estos manuales

Sin comentarios