Carrier-access Adit 3000 Series and Multi-Service Router (MSR) Ca Manual de usuario descargar pdf (Pagina 65)

Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI 3-7

Privileged Mode

debug portmon ethernet

Use the debug portmon ethernet command allows the user to monitor specific Ethernet traffic.

Note: Immediately after this command is issued, any traffic that falls into the filter parameter will

be displayed. To turn the monitoring off, you must issue a no debug portmon command. See no

debug portmon command on page 3-16.

Syntax: # debug portmon ethernet {1|2|both} [all|arp address|bootp

address|control|data|dns address|icmp address|ip address|link|

mgcp address|rip address|sip address|stp|tcp {address|

address:port|port}|udp {address|address:port|port}]

Example: adit 3500# debug portmon ethernet 1 all

Supported Platforms:

Adit 3104, Adit 3200, Adit 3500, MSR

Field Definition

ethernet Display Ethernet traffic.

1 or 2 - Define Ethernet port

both - Both Ethernet ports

Filters all traffic of the following type.

all Allows all traffic.

arp Displays all Address Resolution Protocol traffic.

address = IP address of the interface.

bootp Displays BootP related traffic.

address = IP address of the interface.

control Displays control related traffic.

data Displays data related traffic.

dns Displays Domain Naming Service related traffic.

address = IP address of the interface.

icmp Displays Internet Control Message Protocol related traffic.

address = IP address of the interface.

ip Displays Internet Protocol related traffic Note: Requires an IP address.

address = IP address of the interface.

link Displays link related traffic.

mgcp Displays Media Gateway Control Protocol related traffic.

address = IP address of the interface.

rip Displays Routing Information Protocol related traffic.

address = IP address of the interface.

sip Displays Session Initiation Protocol related traffic.

address = IP address of the interface.

stp Displays Spanning Tree Protocol related traffic.

tcp Displays Transmission Control Protocol related traffic.

address = IP address of the interface.

address:port = IP address

port = Port of the interface

udp Displays User Datagram Protocol related traffic.

address = IP address of the interface.

address:port = IP address:port of the interface.

port = Port of the interface

1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 495 496

Comentarios a estos manuales

Sin comentarios