Carrier Access Network Device Axxius 800 Manual de usuario Pagina 113

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 568
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 112
Axxius 800 - Release 2.2 5-13
CLI Commands
add
add (router) uploaduser
Use the add (router) uploaduser command to specify a host that is allowed to upload either
the configuration or software files to the specified Router card.
Syntax: add {rtr_card-addr} uploaduser {code|config|both}
{all|ip-addr} {"profile-name"}
Example: add 3 uploaduser code all "LosAngeles"
The example will allow any user to upload the code file from the TSR interface
named "LosAngeles". The TSR is located in slot 3.
{rtr_card-addr}
The slot number (1-8) that contains the Router card.
{both|code|config}
{all|ip-addr}
{"profile-name"}
The name of the remote WAN or LAN profile that can be used for the upload. This name
must be enclosed in quotes.
both Will allow user to upload both the code file and the configuration file
from the Router
code Will allow user to upload the code file from the Router
config Will allow user to upload the configuration file from the Router
all Will allow upload from anywhere
ip-addr The IP address to allow upload boot from. In the form of
xxx.xxx.xxx.xxx, where xxx is between 0-255
Vista de pagina 112
1 2 ... 108 109 110 111 112 113 114 115 116 117 118 ... 567 568

Comentarios a estos manuales

Sin comentarios