Carrier Access Network Device Axxius 800 Manual de usuario descargar pdf (Pagina 187)

100

101

Axxius 800 - Release 2.2 5-87

CLI Commands

set

set (fxo)

Use the set (fxo) command to setup one or all of the voice channels of an FXO card. The

command specifies the list of voice channels within that card, and the setting to apply.

Syntax: set {fxo-addr} {setting}

Example: set 2:1 signal ls

Set the FXO on slot 2, port 1 to signaling type loop start.

{fxo-addr}

List of voice channels to apply setting to, in the form {slot:port}.

{setting}

slot Slot number 1-8, location of the FXO card

port Port number or range

rxgain The receive level range is -9 to +7 (db). Available values are -9, -7, -6, -5,

-4, -3, -2, 0, 2, 3, 4, 5, 6, and 7

signal Set the DS0 signaling type

dpt Set the DS0 to Dial Pulse Terminate

gs Set the DS0 to Ground Start signaling

ls Set the DS0 to Loop Start signaling

lscpd Set the DS0 to Loop Start Calling Party Disconnect

txgain The transmit level range is -9 to +7 (db). Available values are -9, -7, -6,

-5, -4, -3, -2, 0, 2, 3, 4, 5, 6, and 7

1 2 ... 182 183 184 185 186 187 188 189 190 191 192 ... 567 568

Comentarios a estos manuales

Sin comentarios

Carrier Access Network Device Axxius 800 Manual de usuario Pagina 187

Comentarios a estos manuales

Relacionado con productos y manuales para Redes Carrier Access Network Device Axxius 800