Carrier Access Network Device Axxius 800 Manual de usuario descargar pdf (Pagina 194)

100

101

5-94 Axxius 800 - Release 2.2

CLI Commands

set

set lsprotect nonrevertive

Use the set lsprotect nonrevertive command to set low speed protected port(s) to non-revertive

mode.

When a port is in non-revertive mode and a failure occurs the port is switched to the protection

port, and will remain there until manually reset. However, if the port becomes healthy again and

another port has a failure the first port will revert, and the second port will then be protected.

Syntax: set lsprotect {slot:port} nonrevertive [priority]

[1-7]

Example: set lsprotect 5:1 nonrevertive priority 2

{slot:port}

The {slot:port} address of the protected port to be configured.

[priority]

An optional parameter, which defines the port priority in the event that multiple protection

requests are received for the same port number on different cards.

[1|2|3|4|5|6|7]

A parameter set with low speed priority, which sets the value of the port priority. Range is

1-7, default is 7. Priority 1 is the highest priority, 7 is the lowest priority.

slot Slot number (1-8) where a Quad T1 card is located

port Port number or range (1-4)

1 2 ... 189 190 191 192 193 194 195 196 197 198 199 ... 567 568

Comentarios a estos manuales

Sin comentarios

Carrier Access Network Device Axxius 800 Manual de usuario Pagina 194

Comentarios a estos manuales

Relacionado con productos y manuales para Redes Carrier Access Network Device Axxius 800