Carrier Access Network Device Axxius 800 Manual de usuario descargar pdf (Pagina 272)

100

101

5-172 Axxius 800 - Release 2.2

CLI Commands

set

set (v54)

Use the set (v54) command to setup V.54 Loopback Test Parameters. The command specifies

the range of channels within that card, and the setting to apply.

Syntax: set {v54-addr} v54 {setting} [off|on] [n] [nnn]

Example: set 6:1 v54 equipment clear

The example will clear the loop test counter on the V.54 card in slot 6, port 1.

{v54-addr}

In the form of {slot:port}.

{setting}

slot Slot number (1-8) of the Axxius chassis where the V.35/54 card is located

port Port number or range.

equipment Set the V.54 Equipment (Tx) parameters:

address

Syntax: set {v54-addr} v54 equipment address {nnn}

Set V.54 loop test address [nnn]

Set the address to be tested.

[nnn] {nnn} must be one of the following:

0 - 255.1, 3, 5, 7, 9, 11, 13, 15,17, 19, 21, 23, 25, 27, 29, 31, 37, 39,

43, 45, 47, 51, 53, 55, 59, 61, 63, 85, 87, 91, 95, 111, 119, 127, 255

(255 disables). See chart below.

clear

Syntax: set{v54-addr} v54 equipment clear

Clear the bit error rate counters during BER test

ignoreack

Syntax: set{v54-addr} v54 equipment ignoreack

{off|on}

Ignore V.54 ACK check [off|on]

Ignore acknowledge from remote equipment. This allows potential

testing with non-compliant equipment by ignoring the acknowledge

phase. WARNING: When choosing this option, the V.35 card

will no longer be compliant with the V.54 specification. Use for

debug purposes only.

loopdown

Syntax: set{v54-addr} v54 equipment loopdown

Stop the test sequence

loopup

Syntax: set{v54-addr} v54 equipment loopup

Start the test sequence

1 2 ... 267 268 269 270 271 272 273 274 275 276 277 ... 567 568

Comentarios a estos manuales

Sin comentarios

Carrier Access Network Device Axxius 800 Manual de usuario Pagina 272

Comentarios a estos manuales

Relacionado con productos y manuales para Redes Carrier Access Network Device Axxius 800