Carrier Access Network Device Axxius 800 Manual de usuario Pagina 177

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 568
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 176
Axxius 800 - Release 2.2 5-77
CLI Commands
set
set(ds0) type
Use the set (ds0) type command to setup one or all DS0s in a DS1 signal type.
Syntax: set {ds0-addr} type {data|voice}
Example: set 3:1:1-4 type voice
To set the traffic type to voice on channels 1-4 on port 1 of slot 3 on a service
card.
{ds0-addr}
The Controller DS0 addresses are different on the DS3 and DS1 Controller, however the
DS0 address on the service cards does not change with Controller type (DS3 or DS1).
{data|voice}
DS0 Address on a DS3 Controller in the form {slot:port:channel:sub-channel}
slot A for the DS3 Controller card.
port Port number, range or all.
ds1 channel DS1 channel number, range or all.
ds0 channel DS0 channel number, range or all.
DS0 Address on a DS1 Controller or service cards (with DS1 or DS3 controller) in
the form {slot:port:channel}
slot A for the DS1 Controller card, or 1-8 for service cards.
port Port number, range or all.
channel Channel number, range or all.
data Set the DS0 up to carry data (clear channel)
voice Set the DS0 up to carry voice traffic (robbed-bit signaling)
Vista de pagina 176
1 2 ... 172 173 174 175 176 177 178 179 180 181 182 ... 567 568

Comentarios a estos manuales

Sin comentarios